Service Tool V3000b

The Service Tool V3400, and administration instrument V3600, enable you to reset the waste ink cushion counter on some Canon printers:You can fathom the messages blunders “Waste Ink Tank Full” or “Waste Ink Pad Full”, “mistake 5B00” or “Blunder P07” on these printers:

  • 66 Southern Blvd. Nesconset, NY 11767 USA Tel: 631-467-3939 Fax: 631-979-0605 [email protected]
  • Pressure Washer Water Pump Fits Honda Excell A01801 D28744 A14292 XR2500 XR2600.
  • Dec 26, 2019 1-Download and introduce the Service Tool Canon V3400. 2-Enter in upkeep mode with the printer: – Power off the printer. – Connect the printer to the focal unit with a USB link. – Hold on the “Resume” catch (triangle around) et squeeze “Power”. – Hold on these two catches until the point that the drove control lights.
V3000b

Service Tool Mp287

1.50' X 1.50' A-Tube Profile - Pre-Drilled Holes - Double 1.50? Flange on One Side #9726; 1.50' X 1.50' P-Tube Profile - No Pre-Drilled Holes - Single 1.50? About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features Press Copyright Contact us Creators.

Canon Pixma iP2700, iP4800, iP4810, iP4840, iP4850, iP4900, iP4910, iP4940, iP4970, iP4980, iP4990, iP5810, iP5880

Canon Pixma MP230, MP240; MP250; MP260; MP270; MP280; MP480; MP490; MP540; MP550; MP560; MP620; MP630; MP640; MP980; MP990; Canon Pixma IX6500, IX6510, IX7000

Canon Pixma IP3600, IP4940

Canon Pixma PRO9000, PRO9500

Canon Pixma MG2120. MG2140, MG2240, MG2250, MG2440, MG3240, MG3140, MG4100, MG4140, MG5140, MG5150, MG5240, MG5340, MG6140, MG6240, MG8140, MG8240

Canon MX397, MX320, MX330, MX860and so forth

How utilizing the Service Tool V3400 ?

1-Download and introduce the Service Tool Canon V3400
2-Enter in upkeep mode with the printer:
– Power off the printer
– Connect the printer to the focal unit with a USB link
– Hold on the “Resume” catch (triangle around) et squeeze “Power”
– Hold on these two catches until the point that the drove control lights.
– Release the “Resume” catch, yet not the power catch, and press 5 times “Resume”.
– Release the two catches. Leds will streak, hold up until the point when it stops. Presently you are in Maintenance Mode
3-Run the Service Tool V3400
4-Choose the privilege USB port in “USB PORT”
5-In the area “Ink Absorber Counter”, pick “Principle”
6-In the area “Counter Value” (%) pick the number the nearest of the counter number and click on “SET” (The counter number is in the segment “EEPROM”)

Service Tool V3000b Software

Investigating:

  • Error 002: a function isn’t supported by the printer
  • Error 005: The printer isn’t good with this Service Tool
  • Error 006